Posts by Bravo Laserworks
The Battery Operated Pocket Jacob’s Ladder
The power supply is a bit much for this scale but I think I can fine tune the electrodes to compensate and get a good la...
Soltron Electronic III Display PCB Voltage Regulator Replacement
This ia a Soltron Electronic III Display PCB from an Ergoline Soltron Chill XL70 Tanning Bed. This board has obvious the...
Meshstastic Off-Grid Com Systems Guide
You're getting an exclusive sneak peek at my book in its early stages! If you spot any errors, have suggestions, or find...
Taking a Hacksaw To My Aurora 8v1
So I'm burning the midnight oil and burning up a few hacksaw blades and cutting up the Aurora a little bit to give a lit...
Step-by-Step Guide: Replacing the Alternator on a 2011 Kia Sedona EX
Step-by-Step Guide: Replacing the Alternator on a 2011 Kia Sedona EX
A Comprehensive DIY Tutorial for Replacing Your ...
The APCO 25 Phase II SDR Receiver
Testing Latency and Audio Compression
.embed-container { position: relative; padding-bottom: 56.25%; height: 0; ...
The 4 Axis CNC Machining Center
Intro
I picked up this Intelitek Expert Mill VMC-0600 with 4 axes, automatic tool changer, pneumatically actuated colle...
The TXC UV Wall Printer
This is the overview of the drive systems. This model uses belts, not the rack and pinion i've recently seen.
...
Thunder Odin Telemetry Project
I came across Node-RED and wanted to see some of what it could do, so I plan on outfitting my Thunder Odin 32-60 with al...
SLA Management